Ford Ranger Courtesy light door switches part number for 1995?
I have a post
of yours about the courtesy door switches on ford ranger and I think I need new ones. Could you provide a part number and a place to order these from?
I have a post
of yours about the courtesy door switches on ford ranger and I think I need new ones. Could you provide a part number and a place to order these from?
Alright… My gas gauge sets right at the top of the E when moving, but when i turn the vehicle off, it will read right under the quarter tank line, than right back to E when it gets turned back on. Would this lean more to the sending unit in the tank or a bad gauge? Fuse is good. Figured i would rather ask before trying either option.
Lot of slop up and down when I shake tire when jacked up, and hums down the road, is this causing the humming
How do I see if its the fuel neck? I used a tiny auto camera to stick all the way down the gas neck and didn't see any holes
I have a stock 1998 ford ranger XLT 2wd at stock hight and currently have have the tire size 225/70R14. I wanted to put 31x10.50R15LT on it. (31 inch tires). Would I have to lift my truck to put that on there or can I ride 31s stock.
I have a few questions about my pickup truck. I'm planning on rear dropping my 97' ford ranger pickup truck. I'm planning on dropping the rear end so it levels to the front end. I was looking for the cheapest method. I have seen videos about just replacing the "shackles" for some shorter ones? And this should drop the rear end of the truck? Also how do I know how much to drop so it looks leveled and not higer or shorter than the front end side of the truck. What should I keep in mind before I do this? I want to know before heading out to a shop so I have some understanding of what to expect to hear. Honestly I wanted to see if I can even do it myself. As I take pleasure from extreme projects like this. Any help is good.
I know Ford owns the Mazda company. And I know the small Mazda pickup is just a re-badged Ranger truck. But what about the other Mazdas? Are they assembled in Ford factories or Mazda factories when they are assembled in the USA? What about if they are assembled in Japan? Is that a shared Ford-and-Mazda factory, or just a Mazda factory, that Ford bought, but then left alone to operate the way it always did? (As you probably guessed, I have not had the best experiences with Fords. But I loved the Japanese Mazda truck that I owned, before Ford bought Mazda.)
Where is the 4x4 fuse located on a 1993 ford ranger xlt