Car insurance, confusing?

I had a Vauxhall Astra and had fully comp insurance, I then sold the car and bought a ford mondeo the same day, I contacted my insurers and asked them to transfer the details over (i have done this previously with a different insurance company). After giving them all the details, i was told that they would not be able to insure my car, i asked why but they couldn't give me an answer. Subsequently i cancelled my insurance (so did the insurance company) and have insurance with a different company. Can anyone explain why they could not insure a ford mondeo even though i had existing insurance with them?

Roman Reigns (Wwe) vs Abraham Ford (The Walking Dead)?

Round 1: Hand to hand combat

Round 2: Wrestling match, win by pinfall or submission.

Both are very angry, Abraham thinks that Roman Reigns is the reason his family died but he can't bring any guns, and Abraham just cost Roman Reigns the Wwe world heaveyweight championship.

How to adjust throttle/idle on 1983 ford e350?

It will start up just fine, but after it worms up it will konk… Konk… Konk out. However, if I slightly keep the accelerator pressed, it stays on just fine. I was thinking about adjusting the throttle or idle or choke. Where is it and how do I do it? If there's a picture somehow, that d be super helpful thanks

1996 Ford Probe GT RPM issues?

I have a 96 Probe GT that is constantly acting like it wants to cut out at low rpms. When the check engine light is off, the car idles at around 1,200 rpm (warm engine). With the engine warm, the car will buck and spudder at low rpms when setting off from a stop or idling. The check engine light will flash for a split second when this happens. Once the car is in third gear and the engine spins at right around 2,000rpm, everything works fine. HOWEVER the car will sometimes start with the check engine light on and it will sometimes stay on. When this happens the car doesn't experience any of the bucking or spuddering at all. I've cleaned out the air filter, changed the spark plugs, and I've had the crankshaft position sensor replaced.

Ford F100 frame strength?

I was wondering if my 1970 f100 could handle around 500ft lbs of torque or do I have to box the frame?

99 ford contour front shake while braking?

Dug into my front end after my rack and pinion went out, i put a new rack and pinion, new tie rods, new ball joints, new sway bar with new bushings and new sway bar links, new strut mounts with new strut bearings.new control arms and new bushings new rotors and new pads, torqued everything to spec but when i brake i get a shake from the front end just like i had before, was thinking calipers or front tire out of balance, thanks for the input