Airbag did not deploy but light is on?

I just got a 2004 Ford Escape. So the panel on the passenger side is part of the way off, pretty minor and I was not in an accident. The airbags didn't deploy but the panel appears to have come loose and the airbag light will not turn off. Can this be fixed and is it expensive?

Car idling at 4000 rpm in park, what could this be?

I have a 2004 Ford Escape, and I was driving it home from work and the brake seemed harder to push to stop, then as I was getting off the highway I took my feet off everything and it was going 50km without me hitting any pedals, then I got into my condo parking lot and parked my car in my spot put it in park and all of a sudden it's rmps just go from like 1 or 2 thousand to 4000. Anyone have any clue what this could be?

2001 Ford Escape runs bad?

I have a 2001 Ford Escape. It cuts out if I push the gas pedal more then a half inch, but if I ease it down it runs smooth. I have replaced the plugs, some vac lines, the PCV, TPS, AIC and checked the gas for water. Before all this I took it to Ford, and was told it had water in the gas and needed plugs. Ford wanted $1000 to fix it. Plugs took me less than 1/2 hour and the gas is clean. Does anyone on here have any ideas what might be the problem?

Is Ford bringing back the Crown Victoria?

I heard from my CHP friends that Ford is brigning back the Crown Victoria. But if they do, wouldn't Lincoln bring back the Town Car since Lincoln and Ford are the same company but Lincoln is the nicer one? Most police officers in California mostly drive the Ford Escape cars, some drive older Crown Victoria's but they did say that Ford is bringing back the Crown Victoria? And is Lincoln bringing back the Town Car?

How to regain pressure in my car brakes after putting in new brake fluid?

I have a 2005 ford escape. The brakes on the car didn't seem to good and i finally lost pressure in the brakes. I refilled the brake fluid and pumped the brakes in hopes that i would regain pressure in the brake but i still have not gotten any pressure out of the brake. I have heard of something called bleeding the brakes but is there anyway to get the brakes to work without doing that. Could anyone tell what i can do to regain pressure in the brakes.