Put new clutch in 1992 ford f150 now won't shift at all?
Put new clutch in 1992 ford f150 now won't shift at all?
Sounds like the release bearing is not traveling enough to actually release the clutch. This happened to me once. Turned out they sold me a faulty clutch plate. Another thing to check is your hydralic cylinder. It may need to be bled.
- Why did my car start and die when put into gear? Now it won't start at all? It's a cold winter day (below zero) Car started right up! I let it run for about 2 minutes, I put it in gear and it just died. I figured it's cold out, not real surprising, but when I tried to start it again, it won't start! Turns over fine but engie won't start! Any ideas? 2003 Ford Taurus 3.0L
- How to diagnose clutch master cylinder or slave cylinder clutch is solid will not disengage can't push in at all? 94 Ford Ranger V6 4.0 2 wheel drive my clutch went solid while driving last night it will not disengage wondering how to diagnose if it's the clutch master cylinder or the slave cylinder please help no fluid leaking anywhere I'm hoping it's just the master I would be the cheap and easy one just don't know how to tell which one is bad
- 1997 Ford Ranger 4.0 V6 won't shift into drive after being driven. Takes longer than should to shift into drive when first started? It will go in reverse fine. First thing in the morning when I leave for work, it will shift into drive on it's own, but takes a bit longer than it should. After getting it warm, won't shift into drive at all. I can shift down to 1st or 2nd, then back into drive and it will "pop up" into drive within a second or 2. I also have a ODB2 error P1744 (Torque Converter circuit).
- I have a 2007 Ford Five hundred that when I shift when it's off it moves. But when I turn the car on & shift it won't move It's a TBS transmission. It's not making any noise either. I was told it could be computer on the transmission?