Do you have to bleed the power steering pump on a 2002 ford taurus after replacing with a new one? If so how?
Do you have to bleed the power steering pump on a 2002 ford taurus after replacing with a new one? If so how?
Yes, and be sure to also give it an enema.
Nope. Just fill the reservoir & start the engine. Don't rev it, just let it idle. The pump will circulate the fluid & fill the bubbles by itself - Just keep adding to the reservoir until it stays at the full mark. Drive it a day, then check & re0fill to the mark as needed. Also, after a day driving, check the noses for drip/leaks, also.
- One side of the power steering rack line on this 91 Ford Taurus is disconnected. Why, and what to do? The power steering rack in my Ford Taurus has a metal rack line that is just laying there unconnected on the front left wheel side of the rack and pinion. Did it just pop out a long time ago? It looks like its been laying there unconnected forever. It seems connected fine on the right hand side, next to the bellows. If I try to plug it back into the fitting for it, will it stay put this time?
- If my power steering pump and pulley break, is there any other parts I may have to potentially replace? Last night when I was driving, my power steering pump busted and also broke my power steering pulley. I have a 2002 ford Taurus. In the process of the pulley breaking off, the serpentine belt came off. It is still on the car so I just have to re position it once the new pulley is on. My question is through this incident, could anything else have broken? I just did a bypass pulley for the AC compressor last week. And I also replaced the serpentine belt last week.
- If you have enough money, can you have a new classic car built? Like can I pay to have ford build me a 1970 Mustang? Lets say I don't want to buy an old car and restore it, I want a 1970 but straight off the factory line. Can you have a car built with the old style frame, engine, trans, etc?
- When changing the power steering pump on a KA (54) can you use PTFE tape to seal the pressure line from pump? I have changed the power steering pump on a ford KA (54) and when removing the pressure line from the pump there was some kind of seal on it but I don't know what it was, so I was hopping that PTFE tape would do the same job at sealing the thread. Any help please. Andy.