When changing the power steering pump on a KA (54) can you use PTFE tape to seal the pressure line from pump?

I have changed the power steering pump on a ford KA (54) and when removing the pressure line from the pump there was some kind of seal on it but I don't know what it was, so I was hopping that PTFE tape would do the same job at sealing the thread.
Any help please.
Andy.

I'd have to say no,
Sealing on these is a very small "O" ring on the very near end of the pipe,
ptfe is really for sealing thread to thread of the fittings.

If it's leaking past the thread, you have a missing or damaged O ring or damage where the parts seat. Don't rely on tape to stop it.

The fittings are pressure fit, and should not require PTFE (Teflon) tape or any other sealant.

O-rings sometimes require special grease to seal, but the power steering fluid should provide the lubricant.

From looking at this pic, it seems to have some white silicone hanging on the pump where the pressure line was.

Edit to add, that could be a white O ring now that Q mentioned it.

When changing the power steering pump on a KA 54 can you use PTFE tape to seal the pressure line from pump

Hi it might work if it doesn't then you will most likely need a new pipe as the have a taper on the thread of pipe which removed the need for a sealant.

  • Power Steering Pressure Switch? I have a 2001 Ford Taurus 24v 3.0l DOHC. I currently have a power steering leak & found out that the power steering pump & pressure switch needed to be replaced. I bought both parts & managed to install the pump with no problems. However, I can't figure out where the power steering pressure switch goes. Does anyone know? I've checked the internet along with youtube & can't find anything that can help me. Your answers are appreciated.
  • One side of the power steering rack line on this 91 Ford Taurus is disconnected. Why, and what to do? The power steering rack in my Ford Taurus has a metal rack line that is just laying there unconnected on the front left wheel side of the rack and pinion. Did it just pop out a long time ago? It looks like its been laying there unconnected forever. It seems connected fine on the right hand side, next to the bellows. If I try to plug it back into the fitting for it, will it stay put this time?
  • My 1999 ford ranger has 20 lbs of pressure on the fuel line. Do i need a fuel pump? After I tested the pressure and shut the motor off the pressure went down to 0 quick. When I just turn the key I don't get any pressure
  • Is it illegal to use coloured tape on Car? Is it illegal to use coloured tape on your fog lights in Ontario? I drive a Ford focus and take transparent blue tape and cover my fog lights rather than my headlights. I understand I'm more likely to be pulled over for drawing attention to myself but don't want to deal with a ticket. Would tape on your fog lights be an "illegal mod?" Thanks in advance!