Rubber hose at intake manifold?
I have a Ford Contour and need to know what and where the soft rubber hose at the intake manifold is. I just need to know what it is and where I can go buy one. I want to order it and install it as soon as possible. Please don't suggest asking a mechanic or auto store.
And just where do you plan on purchasing said hose? A Bakery? Why do you want to replace something you can't even find? I'm smellin' FAIL here. What year Contour and which engine?
Based on the high failure rate and the age (1999, right) I suspect it is the PCV hose. Have a look at one at the local Ford dealer - Ford likes to make them different sizes on each end so they are special - and see if that is it.
- What happens if I remove the cone within the intake hose of my 1991 2.3L Ford Tempo GL? It has a HSC engine. Does the cone create a swirl in the air which the High Swirl Combustion engine needs? Or is it a silencer that I can remove to gain HP and fuel economy? I know these were lemons but it has no rust, was always garaged and has 130K KILOMETERS on it. See my sketch of it below… Thanks for your help.
- Vacuum leak between carburetor and intake manifold? I have a 1966 ford f100 with a 390. After taking off the carb to clean it, I noticed a rough idle and fuel leaking from between the carburetor and intake manifold. So I replaced the gasket with a gasket specifically for Holley carburetors, but that didn't stop the leak. Any ideas? Would there be any reason the manifold or bottom of the carb would need to be resurfaced? Is sealant ever used?
- What parts in an ABS braking system of a 2007 Ford Fusion is rubber or contains rubber? Must know what to buy and replace? I have a contamination of transmission fluid inside my brake fluid reservoir. I know, very bad mistake. I understand what this type of fluid will do to rubber and I need to know the parts of the system I need to buy and replace.
- I need help removing the intake manifold gasket on my 2000 ford explorer xlt 5.0L V8? Does anyone know how to remove an intake manifold gasket on a 2000 ford explorer xlt 5.0L V8? I'm leaking fluid from inside and i have no idea how to remove it properly as I do not want to damage anything. I have searchers the internet and YouTube and have yet to find a proper guide. Would anyone be able to give a detailed guide or have a link to a guide?