Clutch bearings 83 ford ranger?
Bought a clutch kit has a pressure plate a clutch disk of course a pilot bearing a throwout bearing, and one other bearing i'm not sure where it goes, its smaller than the pilot bearing and I don't know what it is. Could someone please help?
It could be the clutch fork pivot bearing. It will be located on the middle of the clutch fork.
Back away from the toolbox.
Hi yes some engine have an additional bearing on the end off the gearbox input shaft which is in the centre of the flywheel which also needs to be replaced as well as the clutch plate and cover and release bearing failure to replace all will be catching you out some weeks later.
- Why do I have to replace bearings on a ford freestyle so much? Just replaced rear bearings on both back tires last yr. Its making the bearing sign noise, why do they go thru so many beaings
- How to replace wheel bearings on a 94 ford ranger 2x4 front and back-Any special tool needed? Lot of slop up and down when I shake tire when jacked up, and hums down the road, is this causing the humming
- How to diagnose clutch master cylinder or slave cylinder clutch is solid will not disengage can't push in at all? 94 Ford Ranger V6 4.0 2 wheel drive my clutch went solid while driving last night it will not disengage wondering how to diagnose if it's the clutch master cylinder or the slave cylinder please help no fluid leaking anywhere I'm hoping it's just the master I would be the cheap and easy one just don't know how to tell which one is bad
- 2009 ford ranger air conditioning compressor clutch bolt broke, clutch fell off,? Bolt stuck in compressor shaft. Best way to get the bolt out, or take the pulley off to get a better grip on the shaft?