95 Ford Ranger gas hand stays on full after installing pump assembly. Intermediately worked before install. Doe's gauge need calibrating?
I had a fuel gauge problem it only worked every now and then it was a disconnected wire at sending unit causing the problem. The problem is before I found this out I started at the slosh module bypassing it this didn't solve the problem. I next replaced the sending unit assembly this is when I found the loose wire. After installing the unit the gauge now pegs past full I removed the bypass from slosh module and it pegged past empty, when I reinstalled the slosh module it pegged past full again. Should I try re-calibrating the gauge or something else? Gas hand slightly moves when ignition is turned on.
Unless your old Ranger has a sentimental value, you shouldn't spending any money on it at all. It's almost 25 years old now. Too many (other) things could go wrong. You'd be better off upgrading to a newer truck.
You did something to the Sender Rod or Float. The Float goes up and down with the fuel level. And when it doesn't the gage doesn't work.
- Why doe my car start, sturtter, then die? I have a 2006 Ford freestyle, sometimes when I start it, it will stutter and die. When this happens all I have to do is give it some gas and it will start just fine. Is this a problem with the fuel pump? Or something else?
- Why didn't Dianne Feinstein hand over Dr. Ford's letter to the fbi after she received and read it? Christine Ford is calling for an fbi investigation. You'd think she'd be smart enough to send that letter to the fbi, or at least ask Feinstein to do so.
- Gas gauge issues 2001 ford ranger 2wd manual 3.0 engine. 12 gallon gas tank? The gas gauge fluctuates between 3/8 and 7/8 somewhat correlating to the amount of gas in my tank but it isn't accurate. What can i do to try and fix this problem? I'm hoping it isn't the float in the gas tank and would like to cover everything else before i drop my gas tank. additional information will be added as requested Gas gauge problems? 2001 ford ranger with a 3.0 engine manual transmission and a 12 gallon gas tank
- 89 Ford Ranger gas gauge is stuck? I haven't actually made a serious effort to fix the problem, but when I do where would be a good place to start?