What tools do i need to remove master cylinder on 2001 ford taurus?
What tools do i need to remove master cylinder on 2001 ford taurus?
Flathead screwdriver for any wiring harness removal, small crescent wrench or a set of standard and metric open end wrenches. The nuts are probably between a 1/2-5/8 or 13mm-16mm.
- How to diagnose clutch master cylinder or slave cylinder clutch is solid will not disengage can't push in at all? 94 Ford Ranger V6 4.0 2 wheel drive my clutch went solid while driving last night it will not disengage wondering how to diagnose if it's the clutch master cylinder or the slave cylinder please help no fluid leaking anywhere I'm hoping it's just the master I would be the cheap and easy one just don't know how to tell which one is bad
- 1990 ford ranger clutch master cylinder? My master cylinder broke so i replaced it it has a hard line going from master cylinder to slave cylinder anyone know how to connect the hard line on my new master cylinder
- How to remove ignition switch Cylinder from 98 ford crown victoria if the ignition cylinder is stuck? I have a 98 crown Victoria. And i used a wrong key by mistake yesterday and now my actual key won't work. I've tried removing the ignition lock cylinder but any video i watch on Youtube tells me to turn the key to replace ignition lock cylinder but i can't do that because its jammed. I've tried jiggling the steering wheel and turning the key but no luck. Pretty sure its the ignition lock cylinder but i can't get the damn thing out without turning the key
- Let the master cylinder run dry and now the brake pedal goes to the floor when I turn the car on. Is air still in the system? I pulled the car out of storage and i noteced the left front caliper was leaking so I replaced the caliper. The only problem was the master cylinder ran dry. I bleed the brakes three times. I did not see any air in the lines after I bleed them a third time. When the car is off the brake pedal gets rock hard when the pedal ia depressed about half way. With the car on the brake pedal goes to the floor. Would this be cause by air in the system? The car is a 03 ford focus.