I need to pull the motor out of my 94 ford taurus, do I need to pull it from the top or the bottom?
I need to pull the motor out of my 94 ford taurus, do I need to pull it from the top or the bottom?
Either way is possible.
It may be easier to drop the whole subframe out the bottom, then everything else becomes much easier to access.
Here is a forum link to procedure and images.
It will have to come out the top.
Assuming you don't have a lift, from the top
- WHAT WRONG? No lecture$. LHF brakes metal to metal week+ Today pedal goes to floor No brake power until almost bottom out Fluid not low? 05 AWD Ford Freestyle. Besides grinding all around brakes were fine. Now noise is close to negligible. Replacing Front pads/rotors tomorrow. A must to bleed now? Air in system? Caliper?
- What is the switch on the bottom side of steering column on a 1979 Ford E250 Econline Van? My van will not shift into reverse or park and will not start. I have replaced the neutral safety switch, checked the shift cable and shift cylinder on the steering column. While doing that is see a sliding electrical switch on the bottom of the steering column which works in conjunction with the shift lever. What does this switch do?
- What's the most a 98 Ford Taurus se pull? I was looking at a boat and only have a 98 Ford Taurus se to pull it what is the most weight to pull out of a lake safely?
- My upper radiator hose is hot and the bottom one is cold, is this a problem? I recently replaced the thermostat and new antifreeze. The top side of the radiator (upper hose area) is very hot, the opposite side (lower hose) is cold. Truck is not overheating, it has great heat, I would sweat to death if I left it on too long. 2003 Ford Ranger 4 Cyl 2.3