How to take out the ignition switch on a 1994 ford ranger?
How to take out the ignition switch on a 1994 ford ranger?
You have to drill it out. When you get a new cylinder, most of them come with the directions of exactly where to drill. Check e-bay for replacement cylinders.
- How to change the ignition switch on a 2000 ford ranger? It has the anti theft protection and a chip in the key. So, my question is, is the dealer the only place that can scan the key and make it work?
- Can my starter burn out if ignition switch is bad? I have a 1990 ford ranger 2.9L Whenever i turn my truck on it starts up but while its on it makes a noise like it's cranking to start. But when I turn it off it still does it and the belts are still rotating also it's does it with out the key in the ignition After that it stops but my starter is burnt out and my positive cable to my battery is Al so burnt
- 1994 ford ranger headlighat switch problem? I have replaced the switch and the connecter that plugs into it. I have had to rewire the headlight wire (red wire) twice now because it keeps melting and last time it melted the connecter. Do I have a short or what?
- Need wiring ignition switch connection DETAILS for 73 (11/72) Ford F100? Wire colors are Yellow, Black, Red w/Blue stripe, Pink, & two (2) Red w/Green stripe (on one terminal). I haven't found anything for these combination of wire color on the web. I need to know where to connect each of these wires… Correctly. I have a ballast, an ignition module, starter solenoid, distributor and coil to connect this specific combination of wires colors to, with this 6 pin switch (only 5 are connected because two red w/green stripe wires are on one pin/terminal)