How to change the ignition switch on a 2000 ford ranger?
It has the anti theft protection and a chip in the key. So, my question is, is the dealer the only place that can scan the key and make it work?
Hi yes he is the only place if you want it to be secure.
- Does the oil pan have to be removed to change the rear main seal on a ford 3.0L V6 in a 2000 ford ranger? I have the engine removed from the truck and was swaping in a salvaged engine that all checks out good except for a slight leaking rear main seal. So, after inspecting the rear main seal, it appears as though a could just slide it out and a new one in. Does the oil pan need to be removed? Or can I just carefully remove the old seal and clean the surfaces good and install a new one?
- Need wiring ignition switch connection DETAILS for 73 (11/72) Ford F100? Wire colors are Yellow, Black, Red w/Blue stripe, Pink, & two (2) Red w/Green stripe (on one terminal). I haven't found anything for these combination of wire color on the web. I need to know where to connect each of these wires… Correctly. I have a ballast, an ignition module, starter solenoid, distributor and coil to connect this specific combination of wires colors to, with this 6 pin switch (only 5 are connected because two red w/green stripe wires are on one pin/terminal)
- How to remove ignition switch Cylinder from 98 ford crown victoria if the ignition cylinder is stuck? I have a 98 crown Victoria. And i used a wrong key by mistake yesterday and now my actual key won't work. I've tried removing the ignition lock cylinder but any video i watch on Youtube tells me to turn the key to replace ignition lock cylinder but i can't do that because its jammed. I've tried jiggling the steering wheel and turning the key but no luck. Pretty sure its the ignition lock cylinder but i can't get the damn thing out without turning the key
- Can you remove the plastic ignition lever/guard around the ignition lock on a 2002 Ford F150? In my 02 F150 there's a plastic sleeve thing around the ignition lock that the key fits into. Is it possible to remove this and reinstall it without breaking it? How?