Very difficult to insert key in ignition in 2010 Ford focus What could be the problem?
I have extra key which doesn't work either
Get the lock cylinder replaced. Not a big deal.
Try WD40 in case it's lack of lubrication. Other than that a new lock is needed.
If lubing doesn't help rick is correct - take your key to the dealer and have them setup a new cylinder for you. The cylinder is easy to remove and replace as long as you can get your key in and turn it. Plenty of youtubes on how to.
Problem with the ignition switch
Do NOT use a liquid lubricant like wd40 - that will cause more harm than good… DO use graphite, which is available at home centers and key shops… The graphite is made for use in locks
- Why did Trump say of Dr. Ford: I thought her testimony was very compelling, looks like a very fine woman and was a very credible witness? I thought her testimony was very compelling, and she looks like a very fine woman to me. A very fine woman. It was incredible. It was an incredible moment, I think, in the history of our country. But certainly she was a very credible witness. She was very good in many respects. https://www.c-span.org/video/?452222-1/president-trump-reacts-calls-delaying-vote-kavanaugh-nomination
- I have a Ford Ranger 4.0 and the AC doesn't blow very cool air. I want to add refrigerant for very 1st time, never have added to any vehicle? I'm using a gauge to test the pressure. With AC on max the needle moves between 25 and 45, the blue normal range. The compressor cuts on at 45 and off at 25. This happens continuously. The outside temp is 80 degrees. Not exactly understanding what I was doing, I added a little refrigerant and now the needle goes to 47 in the yellow range. Will this do any harm? Can I remove the excess refrigerant? If so, how? Is the system fully charged? If so, why isn't the air cooler?
- If I have a 2008 Mercury Mariner and have the key below could I use the standard key and remote? What I mean by standard remote and key is like the ones Ford, Mecury, and Lincoln came out with at first with just a remote and key. Also how would an extra key cost like the one in the picture above? Would it be cheaper to do the the standard key and remote?
- How to remove ignition switch Cylinder from 98 ford crown victoria if the ignition cylinder is stuck? I have a 98 crown Victoria. And i used a wrong key by mistake yesterday and now my actual key won't work. I've tried removing the ignition lock cylinder but any video i watch on Youtube tells me to turn the key to replace ignition lock cylinder but i can't do that because its jammed. I've tried jiggling the steering wheel and turning the key but no luck. Pretty sure its the ignition lock cylinder but i can't get the damn thing out without turning the key