Will a 4.9 liter inline 6 cylinder fit in a 2000 ford explorer?
Will a 4.9 liter inline 6 cylinder fit in a 2000 ford explorer?
Not without a lot of work. The 300 straight six is quite long, but it is a very tough engine. I doubt you could get it into the Explorer.
- Which cylinder is cylinder #5? I posted this the other day but in a hurry with not much detail so here it is again I drive a 2004 Ford taurus with a v6 24v DOHC Duartec engine and my computer is reading a bad ignition coil on (coil e #5) replacing it won't. Be difficult I'm just not sure how to determine which cylinder is which
- How to diagnose clutch master cylinder or slave cylinder clutch is solid will not disengage can't push in at all? 94 Ford Ranger V6 4.0 2 wheel drive my clutch went solid while driving last night it will not disengage wondering how to diagnose if it's the clutch master cylinder or the slave cylinder please help no fluid leaking anywhere I'm hoping it's just the master I would be the cheap and easy one just don't know how to tell which one is bad
- 1996 ford ranger 2.3 liter i did a cylinder head swap to a 1993 mustang 2.3 now timing is off what can i do? Blown head gasket on my 1996 2.3 ford lima engine I was not able to gind a head so I found a head that was for a 1993 mustand 2.3 whit low milage and installed and now my timing is off.
- How to remove ignition switch Cylinder from 98 ford crown victoria if the ignition cylinder is stuck? I have a 98 crown Victoria. And i used a wrong key by mistake yesterday and now my actual key won't work. I've tried removing the ignition lock cylinder but any video i watch on Youtube tells me to turn the key to replace ignition lock cylinder but i can't do that because its jammed. I've tried jiggling the steering wheel and turning the key but no luck. Pretty sure its the ignition lock cylinder but i can't get the damn thing out without turning the key