How to fix surging bogging problem 2005 ford f350 v10 after replacing tps?
So I had a code come up to replace tps so I did.
now truck will bog and sometimes dies when taking off and coming to a stop.
have moved the sensor up and down. Some positions makes the gas pedal not work. With it in the correct spot truck idles around 500 rpms.
I don't get what the problem is. Doesn't make any sense.
could it be that it's not a motorcraft part?
are these v10 picky with aftermarket parts?
any suggestions thanks
Tps installed/adjusted correctly?
cleared fault codes before starting engine?
after clearing codes turned key to on pressed gas pedal slowly to floor several times before starting engine?
possibly a bad tps (rare but does happen) problem might not be tps
You need to follow the manufacturers procedure to set/adjust and program the new TPS. Why you playing mechanic if you have no frickin clue what you are doing?!
OBD2 should tell you what is malfunctioning.
- How to fix a leaky rack and pinions without replacing it? I have a 96 Ford Taurus GL the rack and pinion is leaking fluid I don't have the money to replace the rack and pinion so where would the leak possibly be coming from and is it possible to fix it without replacing the rack and pinion
- Motorcraft 2150 carburetor bogging? I have a 1975 ford, when i start the car it idles real rough for about 30 seconds, when driving it cold it will run good for about 3 minutes then stall, once i get it wormed up a little bit it runs great. I just had the carb cleaned. What could be the issue
- 2005 VW Golf 1.6 or 2005 Ford Fiesta Zetec S 1.6 2005? First car for a 17 year old who has just passed his licence. Both cost similar amounts for purchase and for insurance.
- Tips on replacing brake pads on a 2005 ford explorer? I've done lots of brake jobs but always on older pre 2000 cars. -Is it the same on newer cars? -Do I need to mess with proportioning valves or anything? -never done 4 wheel discs so is there a special order in which I should change them or bleed them? - is there any kinda of sensors I need to reset and if so, how do I reset them? Any help would be greatly appreciated.