What size rear end does a 1990 full size ford bronco have?

I have a full size ford bronco the rear end is no good I was wondering what I can swap it out with what other trucks have the same size the little tag on the rear end says s838b-3.55-88-2e06 any help would be great and on the inside it says axle number 19

Bronco is good…

Hi if only life was that simple.

It has the 8.8 inch rear axle. Yours, like most has 3.55 gears and an open diff

  • Aren't you amazed by the capabilities and the size of today's full-size pickup trucks? I drive a 2011 Ford Ranger XLT 4x2 with a 4.0 liter V6 (~245 ci.) engine. I was looking up the specs for early-mid 1960s F100s (considered full-size), and they have nearly the same GVWR, towing capacity, payload, horsepower, wheelbase, and height as my "compact" truck. In your opinion, do you think today's full-size trucks are amazing or too fancy/over-sized (a traditionalist like me)? P.S.: I like all American vehicles
  • 2007 Ford Ranger rear end jerks on acceleration after a downshift at about 20 MPH? 2007 Ford Ranger 28,000 miles, 8.8" Rear axle 3:18 gears auto trans. Every now and then when I accelerate from around 20 MPH and the truck downshifts there's a small jerk in the rear end a second after the downshift. Is this normal? I just bought the truck and never had RWD before. If someone knows what the problem is that would be awesome!
  • How to decrease the amount of backlash in my Ford 8.8 rear end? I know I can change my ring gear and pinion gear but is there a way to shim the pinion gear? Any suggestions?
  • Ford 8.8 rear end problem? In my crown vic I picked up a used ring gear and pinion and both were in good shape so I swapped in them in place of my stock gears I used the same bearings and factory shims just a gear swap no overhaul since it wasn't needed now I got it all together and there's a noise coming from the rearend its not exactly a whine but the only thing i'm unsure of was setting the pinion. Would that cause a noise?

Add Comment