1990 ford truck has hot wires going to switch?
1990 ford truck has hot wires going to switch?
The ignition switch is used to power numerous electrical parts on the truck. If its anything like the Mustang ignition switch, it has several fusible links in the wiring harness leading to the starter relay(mounted on inner fender usually)eec power relay, blower motor, etc. If you're referring to the starter relay on the inner fender instead of the ignition switch, one cable runs from battery positive to left side of relay and the other large cable goes from the starter to the post on the right side of starter relay. The link below should help you out.Click on the link below and scroll down til you get to the diagram you're looking for then click on enlarge to view the diagram.
http://www.autozone.com/...3f8038ecd6
What Ineed to know is the wires that are in the electric plug that goes up steering wheel shaft to the horn/turn signal assembly. How many of them stay hot all the time.
Your answer was great!
- Why is the temperature guage in my 2000 ford contour going to hot? I have changed the thermostat? It runs with perfection while the reservoir cap is off but as soon as i replace the cap it starts to run hot again. The engine stays cool even when the gauge reads ho
- Where do i put in aw-46 hydraulic fluid in 1990 ford f600 dump truck? I believe it goes in somewhere under the dump box once lifted. is there a link to some specs that i could possibly print out so i can see where to fill it at?
- 2007 ford focus (PZEV) Hard to start. Mornings, hot, cold days, after the car has ran dos nt matter? 2007 ford focus(pzev) hard to start… Mornings, after the car has ran… Dose nt matter weather it's hot, cold.car is still hard to start
- I having problem with my F150 Ford truck 1990? I don't know what the problem with my truck, it run good but if I drive it for a long time and turn it off. It take a half of a hour to start back up. If i stray started fluid into it, it start back up. Do anyone might know the cause of this?