What does a1991 ford wire run to hook up radio?
What does a1991 ford wire run to hook up radio?
Costs vary based on the radio you are buying and the model you are installing into. The factory wiring should be sufficient for most radios, unless you are installing more speakers. For a normal (without subs, separate amp) 4 speaker system in the doors and the rear deck of a sedan, the wiring should not exceed $50. The wire colors changed a few years later, to accommodate a standard wire color chart that most after market radio makers use today.
Car Radio Battery Constant 12v+ Wire: Green/Yellow
Car Radio Accessory Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Red or Black
Car Radio Illumination Wire: Blue/Red
Car Stereo Dimmer Wire: Orange/Black
Left Front (+): Orange/Green
Left Front (-): Black/White
Right Front (+): White/Green
Right Front (-): Black/White
Left Rear (+): Pink/Green
Left Rear (-): Pink/Blue
Right Rear (+): Pink/Blue
Right Rear (-): Green/Orange
This might help…
http://www.installdr.com/installdocs/flm/PDF/356011.asp
Well you can buy harness that fit your model car Best Buy have pretty good prices A NOTE: do not use Amos wire code it wrong you have standard solid red is always power black is ground after that the accessory could be any color so check the diagram for connection.
- Where do you hook the battery charger to jump start 2007 ford E-450? Have a 2007 ford E-450 box truck. Battery is dead and wondering were you hook the charger to jump start the battery.
- Should ford hook lima beans have a syrupy taste? Yesterday we had these lima beans and today we're also having them(tried them to see what they would taste) and they taste like they have a syrupy taste to them. Usually they don't. They are new bags. They never tasted like this before.
- How do I hook up the nuetral safety switch on a 94 Ford Ranger? I have a 94 4wd Ford Ranger with a 4.0 Engine, And i put a A4LD Automatic Transmission in it, but I can't get the Neutral Safety Switch or Starter Safety Switch and now I can turn the ignition and it won't crank or even turn over and I heard that was the problem. I can tell where the plug in goes and the wire that goes to it are the same plug in but I just can't get it to go in can anyone tell me how it goes in if there's a trick to it or something?
- How do I hook up my ecu to my 2005 1.3 Ford Ka? I have a 2005 Ford Ka 1.3 petrol and I have been breaking it, unfortunatly the engine or ecu or shell did not sell. I thought I might get it back going again as a banger but I have cut all the wires on the ecu making it impossible to wire it back together as there's more than one wire the same colour. I have had a look for wording diagram to trace the wire and do it that way but I can't find any wireing diagrams. If anyone could help that would be much appreciated.