Will a 2005 ford F150 5.4 motor interchange with a 2000 ford F150 5.4 motor?
Will a 2005 ford F150 5.4 motor interchange with a 2000 ford F150 5.4 motor?
The 2005 5.4L out an F-150 will be the 3 valve version with VCT. The 2000 F-150 5.4L is the 2 valve without VCT, there are some major differences. The 3 valve has a drive by wire throttle, it's physically larger, and may or may not use difference accessories (PS pump, alternator, etc.) The engine mounts and the bellhousings are the same though IIRC.
If you're doing the swap, a word of advice. Change the spark plugs out of the 3 valve engine before installing it. And be very careful when you do it, as there's a specific procedure to follow so that your don't break the stock two-piece spark plugs when removing them
The basic short block will, but not much else.
- Will a ford taurus car with 3.0L V6 engine be able to interchange with a 3.0L V6 ford ranger? If I purchase a ford taurus for cheap, can I just strip both engines down to long blocks and put the intake, exhaust manifolds, and everything off my ranger over onto the taurus engine, would everything bolt up and work?
- Will a 5r44e interchange with a 4r44e? I have a 99 ford ranger XLT 2WD with a 4r44e and I want to know if a 5r44e will mount to the 6V 3.0L.
- I have a 2005 Ford F1-50 5.4 liter Triton motor 4wd? When engaging transmission into gear a whining noise is heard that sounds like a worn-out hydraulic pump. The sound of the whining increases as the RPMs increase when pulling a hill or an A grade the whining will also get louder. The whining noise does not exist in park or neutral only when engaged in forward gears and reverse. The level of transmission fluid is perfect and was changed 23,000 miles ago. The overall mileage is 80,000 and has been well maintained since it was bought new by me.
- Do 164 tooth flex plates interchange between 1977 351 Windsor and 400 Ford engines? I know the bolt patterns are the same and balance weghts changed on the 302 in 1981 to 50 oz from the 28.2 and that both Windsor and Clevelands used the 28.2 oz. What I want to know is are the dimensions the same from the flange surface of the crankshaft mount to the bolt mount for the torque converter and is the balance weight located in the same place on the flex plate relative to the bolt pattern.