84 ford ranger 2.8 flooding out of carb?
84 ford ranger 2.8 flooding out of carb? - 1
Added (1). carb was rebuilt
I think the float and needle valve is not stopping the fuel from entering the carb.
New carb or rebuild the carb.
Check J C Whitney and carparts dot cam for carb prices and carb rebuild kit prices.
http://www.jcwhitney.com/carburetors-and-accessories/ford-ranger-1984/c2039d658y1984j1s23.jcwx?filterid=d658y1984g88
Rebuild kits
http://www.jcwhitney.com/jcwhitney/textsearch_result.jcw?sku=Carburetors+rebuild+kit&shopid=100001&filterid=d658y1984g88j1
More kits
http://www.carparts.com/results/?searchType=global&N=0&Ntt=Carburetor+Rebuild+Kit&tahsearch=1&tahgroup=UGS&tahrank=19780&tahscore=5.50773
Needle/seat and/or float.
Time for a carb rebuild.
Change the fuel filter too.
The carb was rebuilt
Is this something that has been sitting all winter? First start-up? Even though the carb has been rebuilt, I still would suspect a sticky needle valve due to Ethanol gas. Or, maybe the little spring & pin holding up the float came loose. Instead of tearing it all apart, you maybe able to just remove the fuel line at the carb bowl, shoot some Gumout carb cleaner in the inlet, reinstall the fuel line, see what happens.
- When i go to start my boat it shoots gas back up carb, it is 2300 holly? Just finished valve job, carb overhaul and gas still shoots out the carb.1996 302 ford motor, withholly 2 barrel carb. Keeps fouling the spark plugs from all the gas. What might cause that are where else should I be looking.
- What Ford vehicles with a 302 motor comes with a 4 barrel carb (and only comes 302 with a 4bc)? I have a 1989 mustang gt motor and I'm making it carbureted and I'm looking for any vehicle with a 302 that carries a 4b. I'm going to a junkyard where they don't help with finding vehicles, so it would be helpful to know what vehicles only have a 302 with a 4bc, that way I can look it up on the website and know exactly where its at.
- Hydraulic through carb meaning? My buddy's ford 460 had a couple stuck valves causing this? (His mom had it checked by a mechanic or something a while back. What does this mean? We're hoping it's not a hydro-locked engine.
- For a Ford LTD Crown Victoria 1984 5.0 engine, how to drop down the RPMs on the carb idle? Electric choke thermostat is new and Throtle position sensor is new. Timing is adjusted but the RPMs are still high running at 1400. How can I drop it down to 550? Would appreciate your help greatly.