Ford 2002 speedo and rev counter starts at -20Mph/-2000rpm?
I Have a 2002 Ford fiesta bought at auction, the speedo and rev counter are zeroed at about -20mph so when you are doing 50 it appears as if you are doing 30, replaced the clocks. Before programming new IC i self tested the IC and revs and speed acted as they should but when i programmed the IC to the car the revs and speed reverted to the -20/-2000 position. I put the OBDii software in live view and the speed and revs outputted by the PCM were displayed correctly (iding at about 1100 rpm) but IC still showed -1000ish. Getting error codes u2200-63 and u2197-63. What would be the likely cause?
There should be an adjustment it is usually in the wire leading from the transmission
- Why does my car rev high all the time and drive without me touching the gas? It revs at stop lights and when sitting idle at drive throughs, and when I'm driving highway speed. It'll rev up to almost 3000 rpms especially in idle. It is a ford Taurus 2005 with 99,700 mi on it.
- 2014 Ford Mustang v6 top speed with driveshaft replaced and rev limiter removed? Can anyone tell me the top speed a 2014 mustang v6 305 hp will run as a top speed with the limiter removed and the driveshaft replaced. I aware that the rev limiter stops the car at 115mph and its due to the driveshaft snapping at 135mph. I have ordered a new aluminum drive shaft and am awaiting its arrival but I have been wondering what the top speed of the car is with that being replaced. Also my rev limiter has already been removed.
- I'm looking for the speedo sensor on a 1.6 TDCI Ford Focus? I have to change it following various error codes relating to it (P0500 mainly). I have bought a replacement but can't find where it goes, mainly due to limited under car space, I know it's a fiddly change but easily a DIY. I'm a skinflint you see.
- My husband has a 91 ford f150 4.9L straight 6. It's idleing high like 2000rpm what would cause that? He just replaced the valve cover gasket and changed the oil and filter. Its a manuel transmission and when he started it a back up it idled high. He tried replacing the idle air controller but that didn't help. Any suggestions