I have a 94 ford explorer xlt manual tranni just had new clutch put in r.p.m.high geared n low
I have a 94 ford explorer xlt manual tranni just had new clutch put in r.p.m.high geared n low help?
Added (1). and its 4wheel drive / 2 wheel
Can't say I understand your question the way its worded but I can tell you that changing a clutch in any vehicle should not have any effect on RPMs in any gear. Clutches connect the engine to the driveline but do not affect engine operation.
If it has two shifter cables are they on right?
- Just had new heads and gaskets installed on Ford Ranger 4.0, along with thermostat and radiator cap. After reaching operating temp, upper? Radiator hose swells to full capacity as if it can't handle more pressure. After engine cools off, hose returns to normal size. Should this be happening?
- Have a 2009 Ford Mustang, kept blowing fuse #47, recently had clutch changed out prior to this? Found out a wire harness to 02 sensor was pinched between transmission and engine (easy to overlook harness should run above transmission). After removing harness and fixing. Had to run a push button for starter though. Anyone have this issue and get it solved (starter wise)?
- My ford focus has just had a new coil pack fitted, but the engine management light is still on? The garage has said that it could be the auto sensor… What is this? Will it be an expensive fix? Advice please!
- 2012 Ford Focus 2.0 engine, with code P090C, Clutch B actuator control circuits low, does mean I need a new transmission? The car acceleration during driving is lagging, it's like it does not take off normally, and reverse goes out, until I turn the car off for a while then on again, it responds normally for a short time