Ford explorer 1996 code po171?
Clear code runs great. Check eng. Light runs ruff and sounds like its missing.
Anytime you get a code that says its running lean and you also have a rough idle and misfiring, its most likely caused by a vacuum leak.Let the engine idle, spray carb cleaner around every gasket, vacuum hose, and vacuum operated component. If the engine idles up, down, or the engine stalls you have found the leak.Repair as necessary. The pcv valve and its hoses should also be checked for leaks and clogs.A faulty ignition component can also cause rough idling and misfiring too so check ignition parts if you don't find a vacuum leak.Spark plug wires, distributer cap, rotor, pip sensor inside distributer, coil, and ignition module. The oxygen sensor reads how much oxygen is in the exhaust and a vacuum leak causing extra oxygen to enter exhaust system. The o2 sensor reads this and signals a lean signal.It can also cause the smell of fuel to be pretty strong because the computer richens the fuel system in an attempt to get the air fuel ratio back in spec. An exhaust leak is also considered a vacuum leak
- Code p0171 for 1996 ford ranger 2.3L xl 4cyl Was running rough in idle i would give gas and it would get stuck in higher rpm check engine light came after awhile and it started running fine all on its own hooked up computer reader and got code p0171 system to lean bank 1 can't find a vacuum leak anywhere could it be the IAC or EGR valve?
- Tire pressure for a 1996 Ford Explorer? I will be driving a 1996 Ford Explorer 4x4 next week. I know that with the whole Firestone fiasco years ago, Ford has changed the recommended tire pressure; I can't find a definitive pressure recommendation. If it matters, I will not be going off-road; it will be 20-45 degrees F so there may be snow and ice; and I will be 9000 feet above sea level.
- My 1996 Ford Explorer will not start. SOMETIMES? There's no telling when my explorer wants to start. Usually once a week it just will not start, it will crank and crank but just won't start. I don't understand it. Then sometimes 10 minutes later sometimes 4 hours later it will start right up. It is driving me nuts and i don't want to pay a shop to fix the problem if it's simple.
- 1996 ford explorer sport is shaking and I just replaced the wheel bearing? 1996 ford explorer sport. We just replaced the wheel bearing and sway bar ends. I picked it up from the guy and its still shaking. Any ideas?