What are the cylinder head bolt torque 1995 ford escort 1.9L?
What are the cylinder head bolt torque 1995 ford escort 1.9L? - 1
Read this. http://www.ehow.com/...-19-l.html If you don't understand it get help as torquing down a head is crtical. Done wrong can ruin it. In those instruction what they basically tell you is the pattern(very important), then to loosen them and tighten to 44 ft pounds, then a quarter turn more on each bolt. Always follow the pattern.
- Replaced cylinder heads and head gaskets, but car is still overheating? 97 Ford Taurus, replaced the cylinder head and head gaskets. Car started fine and we let it run for a while before taking it out for a test drive. After about ten minutes the car started to overheat again, coolant came out and steam came from under hood. We also replaced the thermostat. What other possibilities are there?
- Looking for your opinion So I'm a mechanic i replace my head gasket on my 1996 ford ranger 2.3 gasket the head bolts the hole 9 yards I torqued the head 51 to 90 ft pounds and the sequence was 51 to 60 to 80 90 so I don't know if i should re torque head bolts or leave it? I'm afraid if i torque them again one will break what do you think paul?
- 1996 ford ranger 2.3 liter i did a cylinder head swap to a 1993 mustang 2.3 now timing is off what can i do? Blown head gasket on my 1996 2.3 ford lima engine I was not able to gind a head so I found a head that was for a 1993 mustand 2.3 whit low milage and installed and now my timing is off.
- Tstat Ford 94 Mustang: broken bolt, drilled new hole for a bolt? Replacing thermostat in my car when the bolt broke leading us to need to drill a new place for another bolt right next to the old one. Will drilling this and placing a new bolt, hold the thermostat in place and work to keep my car from over heating? I have no idea if doing this will work…