I'm trying to locate the torque specs for water pump bolts on the 2012 Ford Mustang with the 3.7l V6?
I'm trying to locate the torque specs for water pump bolts on the 2012 Ford Mustang with the 3.7l V6?
Added (1). Also, the kit did include a new metal gasket. Would it be wise to put a small amount of RTV around the edges of the metal gasket on both the block side and water pump side? I usually do irregardless of gasket type, just as a preventative. I just wanted to make sure.
I have no doubt there's a torque for every bolt in every car truck or bus but I'll bet you will never find the torque for the water pump in any book you can get. What you can find is the torque for the size and grade of bolt used, or you could just tighten it to your satisfaction.
RTV, why would you not put it on both sides of the whole gasket, what's with the edge thing? And if you use it "irregardless" why are you asking here?
- What are the torque specs here? I'm re-installing a crankshaft for a 1956 ford model 650 tractor. Just wanted to know the foot-lbs specs for the mains and rods
- What is the torque value for bolts on driver and passenger seats? 2007 ford mustang gt 4.6L Automatic Where can i get a manual with this info? Chilton Does NOT have it.
- What car would be better for me 2012 infinity g37 sport or a 2012 mustang gt? I'm 18 and I'm getting ready to get a new car in 2 months. I've been driving an 03 Ford Focus and I'm ready to upgrade. I'm a very responsible driver and I've been driving for almost 4 years. So I wanna know what would be the best vehicle for me. And what is more reliable and cheaper to maintain?
- On my 2000 ford mustang why does my air pump (smog pump) only blow air for 5 seconds after start up? Is that normal? I have p0411 secondary air injection system insufficient flow detected. I've checked the hose that comes out from the pump, it's blowing air but I believe it should blow air for much longer than 5 seconds on start up.