2009 Ford focus injector fuse keeps blowing?
I have a 2009 1.6 tdci Ford focus and while driving it just cut out. After many different attempts at different things wrong, it turned out to be that the fuse for the injectors blew. So we changed the fuse and it blew again while it was driving. I don't have the car long and it recently got a new engine. Anyone know why this is happening?
Take it to mechanics
The circuit is being overloaded. There could be a short to ground or the fuse is not up to the proper rating.
The injector circuit is shorting, a power wire/s is shorting to ground or an injector/s is shorted (no resistance). Time for a tow to a garage.
Disconnect all the fuel injectors and do and ohm test on each of them. If one is out of range it may be shorting the system and blowing the fuse.
Failing injector or fault causing overloading /grounding. These can be tricky to find source without proper testing .a garage ought to run diagnostic and can use a multi meter etc to pinpoint exact area and cause. This sort of niggling faulty can be both time consuming and troublesome so its best to pass to an expert whom will quickly ( normally) trace and fix for you.
- Will a 2000 Ford Windstar lx fuse box diagram be the same as a 2003 Ford Windstar fuse box? I found a link about a 2003 but I need to know if it'll be the same for a 2000. If it ain't can anyone help me out with a link showing information like this but about a 2000 model? Thanks. http://www.fixya.com/cars/t11808484-2003_ford_windstar_fuse_box_diagram
- Why does my fuse keep blowing after I start to drive my truck? I drive a 76 ford f100 and every time my truck is parked and I put a new fuse it all the blinkers work well but as soon as I drive my fuse blows could it be that I have very bad wiring of that i have an open circuit?
- Which fuse is the correct fuse for the radio in a fuse box? Read details? A 2002 wind star ford van has a radio that doesn't work. Which fuse would need to be replaced in the fuse box?
- Have a 2009 Ford Mustang, kept blowing fuse #47, recently had clutch changed out prior to this? Found out a wire harness to 02 sensor was pinched between transmission and engine (easy to overlook harness should run above transmission). After removing harness and fixing. Had to run a push button for starter though. Anyone have this issue and get it solved (starter wise)?