Where do I jack up my 2002 Ford Taurus?

I just bought a 2002 Ford Taurus with the intent to flip it. I found out that the gas tank is leaking on it. The car is originally from Ohio meaning it has driven over a lot of salted roads during the winter. The car's manuel recommends using the notches just under the door and in front of/behind the wheels as jack points. Both notches on the rear of the vehicle are rusted out (gone), so how am I supposed to raise the back side of my vehicle up to look at the gas leak?

2004 Ford Taurus transmission hard shift from 1st to 2nd. What are the possible causes?

2004 Ford Taurus transmission hard shift from 1st to 2nd. What are the possible causes?

Added (1). Should i replace the VSS / speed sensor, change the tranny fluid and filter or change the valve body. Please replay only if you fixed the problem similar to mind and state what exactly did you do to correct the issue. Please it does not help me and other is you guess a solution. Please only state the exact fix that worked for you.

What is causing belt noise in my 2003 ford taurus?

Just replaced my alternator and a few days later started to get belt noise. Replaced the belt and idler pulley since they seemed to be the top causes and the noise went away for about a day. Noise is now back and I can't figure out what is causing it. It seems the next common cause is the belt tensioner pulley but when i take the belt off the pulley spins freely without a problem. The ac pulley seems to spin freely as well. The noise gets worse as the rpms go up and I'm all out of guesses on what it could be.

Car Problems. Engine light

I have an 06 Ford Taurus. My check engine light is on and I got it checked its a cylinder 6 miss fire. It doesn't tell me the exact problem but the car putters when starting and when trying too move forward after stopping at a light etc. But runs fine otherwise. I can't afford much so was hopeing to figure out problem before getting serviced.

How to improve a 1999 Ford Taurus SE sedan 3.0L V6?

So I bought my grandparents car off them and it runs well and I'm not going for a full blown rally car I just want a sleeper that I can take to the track every now and again and be able to out perform a few unknowing friends, so how can I squeeze a little more hp out of it? (I don't care about suspension cause this is just a sleeper)

Do I need Valve Cover Gasket?

Do I need the actual gasket, or can I use just gasket maker, or should I be using both? My father insists it's all I need, but I just want to make sure before I take everything apart.

2002 Ford Taurus se