How much is this fixer upper? 2001 Ford Taurus runs a little rough. Gas hog, and cosmetics?
How much is this fixer upper? 2001 Ford Taurus runs a little rough. Gas hog, and cosmetics?
What codes is throwing? Have you plug obd in it?
We have no idea, it depends how bad it really is, how many miles, how rough, how clean is the interior, do accessories like air conditioning and power windows work, and how much the current owner wants for it.
In my area, any car that starts up moves when you press the gas, stops when you press the brakes and turns when you turn the wheel is worth at least $1000 and in most cases $2,000.
It will likely fail emission. Stay away unless the seller gets it smogged for you.
- 2007 Ford Taurus rough idle and dies of I don't put my foot on the gas? I have a 2007 Ford Taurus that has a very rough idle but once I get to 30 miles per hour or so everything is fine. Since this started my battery is always dead when I go to start my car. I've replaced the ignition coil and the wires cause autozone said that was the problem. But it still is acting the same way. The car dies when in idle and I don't know what else to do. Any help is appreciated.
- Just had new heads and gaskets installed on Ford Ranger 4.0, along with thermostat and radiator cap. After reaching operating temp, upper? Radiator hose swells to full capacity as if it can't handle more pressure. After engine cools off, hose returns to normal size. Should this be happening?
- Ford Ranger 4.0, 172,000 miles rough idle when starting after sitting overnight or after 2-3 hours. Starts 1st crank, idles rough 1 minute? Or so and then smooths out and runs fine. New heads and gaskets. Cleaned MAF sensor, throttle body and air intake sensor, new IAC valve, new air and fuel filters, new PCV valve. No smoke coming from exhaust and No check engine light. Any ideas what's causing this rough idle?
- I bought an Actron CP9125 Code Reader to try and diagnose a rough idle at cold start on a 98 Ford 4.0 engine. The rough idle had not caused? The CEL to come on. I plugged the code reader in with just the key on and pressed read and the little asterisk goes half-way across the screen one time and stops. I press the read button again and it reads 0 codes. I was thinking it would scan multiple times to check for pending codes or other issues. I tried it with the engine running and the same thing happens. Is this code reader operating properly?