I have 1991 ford ranger with 3.0 engine. When I try to start it has no spark unless I disconnect and reconnect battery. Any ideas?
I have 1991 ford ranger with 3.0 engine. When I try to start it has no spark unless I disconnect and reconnect battery. Any ideas?
Maybe you need to tighten the connections. But with a truck that's almost 29 years old, there are MANY problems you might have. It would be best to replace it.
Clean and tighten the battery terminals.
- Restoring old Ford Transit. Can't get engine to start. Any ideas please? Friend is restoring 1976 Transit Diesel. Dry stored and in excellent condition. Re-conditioned injectors, clean fuel. Engine turns over valve-gear working (belt intact). Compression, fuel at injectors, no air in system engine turning over with new battery. Apparently no heater plugs on this engine (2.4). Tried eze-start just 'coughs' but will not actually start. At wits end! Any ideas please?
- My buddy has a 99 Ford Ranger XLT 4x4 that is leaking oil from rear passenger wheel. Any ideas on why? The brake cover is not pushed all the way against the hub. There's a half inch gap between them. Don't know if that has anything to do with it. So it has nothing to do with the wheel bearing?
- I have a 97 Ford Ranger, 4.0, in good shape, 102,000 miles and it doesn't start as well as I think it should. It cranks strong, and has new? Motorcraft plugs and fuel filter. I've cleaned the MAF sensor and throttle body and the truck runs fine and there's no misfire. Maybe I'm expecting too much, but I think the truck should start when I turn the key instead of having to crank 2-3 times. I've also installed a new IAC valve. Any suggestions on how to get the truck to start better?
- I bought an Actron CP9125 Code Reader to try and diagnose a rough idle at cold start on a 98 Ford 4.0 engine. The rough idle had not caused? The CEL to come on. I plugged the code reader in with just the key on and pressed read and the little asterisk goes half-way across the screen one time and stops. I press the read button again and it reads 0 codes. I was thinking it would scan multiple times to check for pending codes or other issues. I tried it with the engine running and the same thing happens. Is this code reader operating properly?