I did a head gasket on a 1996 ford Ranger 2.3 torque sequence was 51 ft to 60 ft to 80 ft to last 90 ft I just did 2 51 and 90
I did a head gasket on a 1996 ford Ranger 2.3 torque sequence was 51 ft to 60 ft to 80 ft to last 90 ft I just did 2 51 and 90
A block of cheddar cheese.
- How long will it take to put a head gasket in a 2000 ford taurus? Just need to know cuz my husband is workin on one for someone else so he can charge them the right price
- Looking for your opinion So I'm a mechanic i replace my head gasket on my 1996 ford ranger 2.3 gasket the head bolts the hole 9 yards I torqued the head 51 to 90 ft pounds and the sequence was 51 to 60 to 80 90 so I don't know if i should re torque head bolts or leave it? I'm afraid if i torque them again one will break what do you think paul?
- 1996 ford ranger 2.3 liter i did a cylinder head swap to a 1993 mustang 2.3 now timing is off what can i do? Blown head gasket on my 1996 2.3 ford lima engine I was not able to gind a head so I found a head that was for a 1993 mustand 2.3 whit low milage and installed and now my timing is off.
- Car overheats, AC is blowing warm, and gurgling noise from head gasket? My 2000 Ford Mustang has been acting up ever since I replaced the upper radiator hose. The hose had a massive hole burned into it from God knows what. It has been overheating recently, and just now after a short drive there was a loud gurgling noise and leak from the head gasket area, right next to where the oil gets poured in. I'm not sure where to go from here, advice?