On a 1996 Ford Thunderbird which line coming from the master cylinder is for the rear brakes?
On a 1996 Ford Thunderbird which line coming from the master cylinder is for the rear brakes?
Huh?
Normally it is the line on the rear of the master cylinder. It is easy to find out. Just follow the line and see where they go.
- Which cylinder is cylinder #5? I posted this the other day but in a hurry with not much detail so here it is again I drive a 2004 Ford taurus with a v6 24v DOHC Duartec engine and my computer is reading a bad ignition coil on (coil e #5) replacing it won't. Be difficult I'm just not sure how to determine which cylinder is which
- How to diagnose clutch master cylinder or slave cylinder clutch is solid will not disengage can't push in at all? 94 Ford Ranger V6 4.0 2 wheel drive my clutch went solid while driving last night it will not disengage wondering how to diagnose if it's the clutch master cylinder or the slave cylinder please help no fluid leaking anywhere I'm hoping it's just the master I would be the cheap and easy one just don't know how to tell which one is bad
- 1990 ford ranger clutch master cylinder? My master cylinder broke so i replaced it it has a hard line going from master cylinder to slave cylinder anyone know how to connect the hard line on my new master cylinder
- Let the master cylinder run dry and now the brake pedal goes to the floor when I turn the car on. Is air still in the system? I pulled the car out of storage and i noteced the left front caliper was leaking so I replaced the caliper. The only problem was the master cylinder ran dry. I bleed the brakes three times. I did not see any air in the lines after I bleed them a third time. When the car is off the brake pedal gets rock hard when the pedal ia depressed about half way. With the car on the brake pedal goes to the floor. Would this be cause by air in the system? The car is a 03 ford focus.