Driving cammed 2010 mustang Gt without tune?

I just installed some Ford hot rod camshafts in my 2010 mustang GT and also have shorty headers, a cold air intake, cat back exhaust, and 24 lb ford racing injectors and was wondering if it is safe to drive for 2 weeks without a tune, my dyno appointment isn't until the 22nd, it does run and drive fine just don't know if i can mildly drive it for now

If it runs fine, why are you asking?

I would have it tuned. If you're not very mechanically inclined you could run the engine too hard if you didn't set up the cams right. The intake and exhaust change the back pressure a lot. Just don't take it to redline

Ideally no, but if you take it easy, you will probably be fine.

Here's the real deal: If that car does not use stock wideband O2 sensors, on cold engine operation, and heavy throttle (acceleration) the O2 sensor is not used to modify fuel trim. Since you increased the lb/hr of the injectors, you richened the mix across the board, then you changed the airflow through the cam and headers, which will lean the engine out. My suspicion is that you will still show lean under heavy throttle until tuned, which of course is very dangerous if you don't take it very easy.

When you get your dyno appointment, you will remember these words: just because it FEELS like it runs fine, when it is hooked up to the appropriate instruments, you will see that it is NOT fine. Guaranteed the tune will increase power a large amount. A lean running engine can feel like it's running ok, but it's not.