2008 Ford Mustang clutch problems?
I have a 2008 Ford mustang v6 stick that is having a problem. Clutch feel is great and has no problems. You can turn the car on and it runs. But when you put it into gear, nothing happens. Even if you leave it in gear and take your foot off the clutch, it stays running. It won't move at all. Does anyone know the cause?
First thing I would check is to make sure the drive shaft is still connected. If so then chase a clutch issue - perhaps it is sticking in full release mode. Clutches wear out very slowly so you would have had an indication that it was getting low on friction pad.
That's a transmission problem, not a clutch problem. Sounds like your tranny is shot.
Have someone in the car with it in gear. While you look underneath it. If drive shaft is moving then you have a rear end or transmission problem. Find local shop at ATRA.COM for more help
Hi yes the thrust bearing has broken as is the case when some one changes the clutch plate and pressure plate. And tries to save money by not replacing the bearing which disintegrates later as has happened here. So it all has to come apart again so extra expense is involved. So when it is apart replace the lot other wise it will happen again as sure as god made little green apples.
- Shifting problems and intake problems? I drive a 1997 ford ranger with a 2.3l automatic. I have recently experienced a hard shifting in my truck even when I'm not on the gas it has problems shifting. And I cleaned my air filter and filter hose that goes to my throttle body and there was transmission fluid in the hose. What can be causing this and how can I fix it or how much will it cost roughly?
- My 2008 ford ranger Truck is making a Grinding noise when clutch is engaged/press. What are my options? I attach a youtube video of a different car making the same sound. Is my only option to replace the clutch or can it be adjusted? If anybody could link a repair manual to a 2008 ford ranger that would be awesome. I tried google and torrent sites but had no luck
- How to diagnose clutch master cylinder or slave cylinder clutch is solid will not disengage can't push in at all? 94 Ford Ranger V6 4.0 2 wheel drive my clutch went solid while driving last night it will not disengage wondering how to diagnose if it's the clutch master cylinder or the slave cylinder please help no fluid leaking anywhere I'm hoping it's just the master I would be the cheap and easy one just don't know how to tell which one is bad
- 2009 ford ranger air conditioning compressor clutch bolt broke, clutch fell off,? Bolt stuck in compressor shaft. Best way to get the bolt out, or take the pulley off to get a better grip on the shaft?