Wheres the PCV on a Ford Fiesta 2001 1800cc endura diesel. The manual is a very vauge?
Wheres the PCV on a Ford Fiesta 2001 1800cc endura diesel. The manual is a very vauge?
It's apparently located in the cam cover - below the disc at the opposite end to the oil filler cap.
- Why did Trump say of Dr. Ford: I thought her testimony was very compelling, looks like a very fine woman and was a very credible witness? I thought her testimony was very compelling, and she looks like a very fine woman to me. A very fine woman. It was incredible. It was an incredible moment, I think, in the history of our country. But certainly she was a very credible witness. She was very good in many respects. https://www.c-span.org/video/?452222-1/president-trump-reacts-calls-delaying-vote-kavanaugh-nomination
- I have a Ford Ranger 4.0 and the AC doesn't blow very cool air. I want to add refrigerant for very 1st time, never have added to any vehicle? I'm using a gauge to test the pressure. With AC on max the needle moves between 25 and 45, the blue normal range. The compressor cuts on at 45 and off at 25. This happens continuously. The outside temp is 80 degrees. Not exactly understanding what I was doing, I added a little refrigerant and now the needle goes to 47 in the yellow range. Will this do any harm? Can I remove the excess refrigerant? If so, how? Is the system fully charged? If so, why isn't the air cooler?
- Why does my PCV valve have a wiring harness that attaches to it? 2004 ford taurus 3.0l flex? 2004 ford taurus 3.0l flex. I pulled the PCV valve out to clean/inspect it and it has a wiring harness attached to it. I have never seen one like this, the replacement part is confirmed identical with the same harness receiver. I have had no luck searching forums or the internet to explain their purpose or what type of sensor may inside this thing.
- My Ford fiesta 1.4 diesel van head gasket? My Ford fiesta 1.4 diesel van started over heating the other week I took it to the garage and they said that it's the head gasket so they want to put a second hand engine in it but I've herd of skimming the engine which is alot cheaper any opinions what to do?