How to remove the bolts under the center console on a 2005 ford f150?
These are the bolts that go up into the console for you to use nuts on to bolt the console down. I have tried to use a socket on them but clockwise nor counterclockwise wise seems to loosen them.
On fords after 2007 you need a grunion plunger compression hex tool.
Prolly spotwelded tabs
The answer is use a 6 mm socket and crank counterclockwise with a breaker bar of some sort and they will slowly come out. Here's the issue the bolts protrude of the bottom of the chassis exposing them to the elements potentially causing rust and making them stick very well!
They are probably speed nuts or clips, once they strip onto the end of the stud or screw you have to get under them with a small screw driver to get them to thread off the stud. They are not often used on a dash panel where you can't pop a plastic cover to get at the top of the nut in normal US manufactured vehicles. Using a good set of lineman's pliers, you can usually pull on them enough as you twist CC to get them to thread off, or you can pull on the part connection to get them going sometimes when plastic allows.
- If the Dems are the nice party in America then why did the Vietnam War escalate under LBJ and finally end under Ford? If the Dems are the "nice" party in America then why did the Vietnam War escalate under LBJ and finally end under Ford?
- How to undo bolts on Ford Galaxy 2003 Front & Rear brake caliper to renew disc's and pads? I need to renew the disc's and pads at the front and rear of Ford Galaxy 2003. I have the correct sockets and a large extension bar, but they will not budge (front or rear). I have tried WD40, thinking of trying a little heat, but its a bit near to the brake hoses. All suggestions gratefully received. I have a full workshop manual on this car issued by Ford which just says that they are tightened to 190Nm. The front bolts are huge 27mm and the rear bolts are 18mm.
- Where can I find custom center caps for a 2014 ford focus st? I have a 2014 Ford Focus ST. I have been looking for a punisher center cap to put on it but haven't been able to find anything for it.
- How can I remove the 4 bolts on the drive plate attaching the torque converter? Ford Laser 2001 automatic 1.6L There's no window to access the bolts which are attaching the drive plate with torque converter like in camry. Thanks for your answer. My next problem is locking the flex plate. Can I use a flat screw driver to lock the drive plate?