Gas gauge doesn't work in a 2001 Ford Expedition. Would it be the fuel pump sender and pressure sender?
I'm hoping it could be something else that could cause the gas gauge not to work.
Added (1). I meant to say pressure sensor
Check all the fuses first. Then the gas tank has to come out and the wiring gets tested. Ground out the wire going to the gauge and see if the gauge reads full. If it does I'd put a new sending unit in the gas tank.
- Would a faulty water pump, on a 04 Ford Freestar, cause the Fuel Rail Pressure Sensor to go bad? There's definite spray pattern on the underside of the hood from the water pump going. Could antifreeze have gotten into the fuel rail sensor and caused it to fault? Is it possible to clean the Fuel Rail Pressure sensor or any corrosion? Part is EXPENSIVE.
- My 1999 ford ranger has 20 lbs of pressure on the fuel line. Do i need a fuel pump? After I tested the pressure and shut the motor off the pressure went down to 0 quick. When I just turn the key I don't get any pressure
- Gas gauge issues 2001 ford ranger 2wd manual 3.0 engine. 12 gallon gas tank? The gas gauge fluctuates between 3/8 and 7/8 somewhat correlating to the amount of gas in my tank but it isn't accurate. What can i do to try and fix this problem? I'm hoping it isn't the float in the gas tank and would like to cover everything else before i drop my gas tank. additional information will be added as requested Gas gauge problems? 2001 ford ranger with a 3.0 engine manual transmission and a 12 gallon gas tank
- When changing the power steering pump on a KA (54) can you use PTFE tape to seal the pressure line from pump? I have changed the power steering pump on a ford KA (54) and when removing the pressure line from the pump there was some kind of seal on it but I don't know what it was, so I was hopping that PTFE tape would do the same job at sealing the thread. Any help please. Andy.