Rough idle and code p0171 ford zx2?
Here's the deal. I've replaced damn near everything. Fuel filter injectors plugs coil wires PVC valve and both elbows did a timing belt and components job. I've got a lean code a rough idle and no low end power. It's been like this since I bought it and I can't figure it out. Any help would be appreciated
The code is:
P0171System too Lean (Bank 1)
Check for a vacuum leak.
Time for a new catalytic converter, most likely.
- 2007 Ford Taurus rough idle and dies of I don't put my foot on the gas? I have a 2007 Ford Taurus that has a very rough idle but once I get to 30 miles per hour or so everything is fine. Since this started my battery is always dead when I go to start my car. I've replaced the ignition coil and the wires cause autozone said that was the problem. But it still is acting the same way. The car dies when in idle and I don't know what else to do. Any help is appreciated.
- Why does my Ford Ranger start rough idle when engine is hot? I have a 2002 Ford Ranger XLT 4X4 with 4.0 litre SOHC engine, it starts good when cold, but I get a rough idle start when the truck was already used and heated up. Engine diagnostics show nothing, I changed the air filter a month ago, changed platinum plugs and plug wires last year, regular oil and filter changes been done. I'm running out of ideas on the cause of this rough idle. Any suggestions, please answer.
- Ford Ranger 4.0, 172,000 miles rough idle when starting after sitting overnight or after 2-3 hours. Starts 1st crank, idles rough 1 minute? Or so and then smooths out and runs fine. New heads and gaskets. Cleaned MAF sensor, throttle body and air intake sensor, new IAC valve, new air and fuel filters, new PCV valve. No smoke coming from exhaust and No check engine light. Any ideas what's causing this rough idle?
- Code p0171 for 1996 ford ranger 2.3L xl 4cyl Was running rough in idle i would give gas and it would get stuck in higher rpm check engine light came after awhile and it started running fine all on its own hooked up computer reader and got code p0171 system to lean bank 1 can't find a vacuum leak anywhere could it be the IAC or EGR valve?