2008 ford escape soft to no brake paddle. Replaced Calipers, pads, front hoses, master cylinder, brake booster, brake module
2008 ford escape soft to no brake paddle. Replaced Calipers, pads, front hoses, master cylinder, brake booster, brake module - 1
You still have air in the lines.
Did you bleed the air out of the lines?
Are you loosing fluid? Did you get the system bleed properly?
You have air in the system. Bleed the lines.
You need to bleed the air out of your brake lines.
Improper bleeding procedure.
Having fun playng mechanic yet?
Hi so after a number of years hydraulic fluid is in need of being replaced by the fact it absorbs water and then the water when it boils after heavy braking expands as steam and causes brakes to lock up and also go spongy.
Likely air in the lines. Make sure calipers are installed with gravity bleed screw on the top. I bleed the furthest caliper from the master cylinder first and then work your way to the closest.
I just let gravity do all the work and let lots of old fluid come out.
Cool
- How to diagnose clutch master cylinder or slave cylinder clutch is solid will not disengage can't push in at all? 94 Ford Ranger V6 4.0 2 wheel drive my clutch went solid while driving last night it will not disengage wondering how to diagnose if it's the clutch master cylinder or the slave cylinder please help no fluid leaking anywhere I'm hoping it's just the master I would be the cheap and easy one just don't know how to tell which one is bad
- How to undo bolts on Ford Galaxy 2003 Front & Rear brake caliper to renew disc's and pads? I need to renew the disc's and pads at the front and rear of Ford Galaxy 2003. I have the correct sockets and a large extension bar, but they will not budge (front or rear). I have tried WD40, thinking of trying a little heat, but its a bit near to the brake hoses. All suggestions gratefully received. I have a full workshop manual on this car issued by Ford which just says that they are tightened to 190Nm. The front bolts are huge 27mm and the rear bolts are 18mm.
- How to get the bolt out for the front calipers on a 2002 Ford windstar? I have a 2002 Ford Windstar and the front bolts that hold the caliper on are rusted and want back out. Looking for information on how to get them out so I can replace the brake pads. The bolt heads are so rust that you can't get a socket on them.
- Let the master cylinder run dry and now the brake pedal goes to the floor when I turn the car on. Is air still in the system? I pulled the car out of storage and i noteced the left front caliper was leaking so I replaced the caliper. The only problem was the master cylinder ran dry. I bleed the brakes three times. I did not see any air in the lines after I bleed them a third time. When the car is off the brake pedal gets rock hard when the pedal ia depressed about half way. With the car on the brake pedal goes to the floor. Would this be cause by air in the system? The car is a 03 ford focus.