Carburetor identification problems?
I have a ford f 250 that I need to rebuild the carburetor for. It's from an '85 and a single barrel. There was no tag but on the front is the number 6-2228, on the side is a big 4 with 02395 under it. 70605 stamped under it. It was manufactured by carter for motorcraft. There were a few other numbers stamped on smaller parts but I don't know if they are relevant. Is it possible to use these to identify what it is through this or am I skrewed?
Call these guys. They look like they got it covered. Your carb numbers look like legit ones. There a contact box on top of the pate to get a hold of them. Preferable calling. At least if you don't buy from them you can use mthe info they give you to look else where…http://www.guaranteedcarburetors.com/
- Vacuum leak between carburetor and intake manifold? I have a 1966 ford f100 with a 390. After taking off the carb to clean it, I noticed a rough idle and fuel leaking from between the carburetor and intake manifold. So I replaced the gasket with a gasket specifically for Holley carburetors, but that didn't stop the leak. Any ideas? Would there be any reason the manifold or bottom of the carb would need to be resurfaced? Is sealant ever used?
- Shifting problems and intake problems? I drive a 1997 ford ranger with a 2.3l automatic. I have recently experienced a hard shifting in my truck even when I'm not on the gas it has problems shifting. And I cleaned my air filter and filter hose that goes to my throttle body and there was transmission fluid in the hose. What can be causing this and how can I fix it or how much will it cost roughly?
- Motorcraft 2150 carburetor bogging? I have a 1975 ford, when i start the car it idles real rough for about 30 seconds, when driving it cold it will run good for about 3 minutes then stall, once i get it wormed up a little bit it runs great. I just had the carb cleaned. What could be the issue
- Why won't the gas in my fuel tank go in the carburetor? 1984 Ford F-150 302 5.0 Automatic? I have put a new fuel tank, new starter, new battery, new fuel lines, the fuse is good for the fuel tank. I have at least a 1/4 of a tank in the fuel tank, i can only get it to run if i put gas directly into the carb, it won't flow from the furl tank to the carb. What should i do? Please Help. * i meant new fuel pump, not tank.