Torque specs on intake manifold 460 ford?
Torque specs on intake manifold 460 ford? - 1
I'm sure there's a torque spec for every bolt on the car, problem is you won't find it. You would be better off looking at the head of the bolt for the grade markings and then Google the torque for the bolt being used.
Tighten manifold attaching bolts in 3 steps:
8-12 ft-lbs
12-22 ft-lbs
22-35 ft-lbs
Don't forget to close the question. Thank you. 
- What are the torque specs here? I'm re-installing a crankshaft for a 1956 ford model 650 tractor. Just wanted to know the foot-lbs specs for the mains and rods
- Vacuum leak between carburetor and intake manifold? I have a 1966 ford f100 with a 390. After taking off the carb to clean it, I noticed a rough idle and fuel leaking from between the carburetor and intake manifold. So I replaced the gasket with a gasket specifically for Holley carburetors, but that didn't stop the leak. Any ideas? Would there be any reason the manifold or bottom of the carb would need to be resurfaced? Is sealant ever used?
- 95 Ford Taurus Speaker Specs? I have spent a lot of time searching and have no results. I know the rear speakers in my Taurus (GL) are 3.2 ohms, but I need too know what the front (door) speakers are rated at ohm-wise.
- Rubber hose at intake manifold? I have a Ford Contour and need to know what and where the soft rubber hose at the intake manifold is. I just need to know what it is and where I can go buy one. I want to order it and install it as soon as possible. Please don't suggest asking a mechanic or auto store.