Why is my 1992 ford explorer it will go in reverse but won't move when put in drive why?
Why is my 1992 ford explorer it will go in reverse but won't move when put in drive why?
Have you checked the fluid level? Did the fluid smell burnt, or was it brownish in color when you checked it? I would almost bet the ranch that the Forward drive clutches are worn plumb to the steel backing plates.
Tranny is probally bad could of dropped a gear
- My 1995 ford contour will start and run but will not move when i put it in gear it is a 5 speed fwd? I realized the other day it had less than a quart of transmission fluid and it was really light colored almost as if it was watered down and i'm wondering would that causze it to not move it will go into gear just won't move
- I have a 2007 Ford Five hundred that when I shift when it's off it moves. But when I turn the car on & shift it won't move It's a TBS transmission. It's not making any noise either. I was told it could be computer on the transmission?
- I have 1998 Ford Windstar as of now when I put in drive/reverse it won't move. It just revs. The car starts up fine? It started while I was driving down the road and I pressed the gas to go a little faster and my rpm went up to 4 and went down. I have an automatic too. There's no burnt smell in my transmission fluid stick/tank. I just left the gas station before this happened if that helps. Any ideas? Someone suggest my second/reverse band and I have never heard of it.
- My car won't move in drive or reverse? I have a 96 ford thunderbird 4.6L v8 I was going down the road about 40 mph when I heard a deep kind of grinding/screeching noise under my car it was raining so I didn't pay it any mind thought a belt was wet or something but then I pulled into a parking lot and then it started to shake/vibrate and then my rpms went through the roof I could not reverse or drive I thought it could be u-joints or flex plate (btw it was the first time actually driving the car in about a year)